Last week I was extremely lucky to have the opportunity to visit the Airbus Helicopter Factory in Donauwörth, Germany.

Our whistle-stop tour of the factory was led by Amaury Bastos, beginning in the composite workshop where over 110,000 parts are produced yearly for the H135, H145, H160, NH90 and Tiger. Larger components included the cabin framework of the H135 and H145 cockpit – which weighs only 11kg! and whilst rose over 7ft from the ground was easily lifted by two people, the whole lower shell of the floor area of the NH90 (made in a single piece) – so big it resembles a small swimming pool! and the tail boom, including fenestron cover, for the H145 which is formed in just 3 pieces, riveted together after ‘baking’.

Each workspace is dedicated to a specific part where layers of ‘carbon fabric’ are built up with a ‘honeycomb’ material used for areas which require additional strength. The process is entirely manual using laser technology to ensure the ‘carbon fabric’ is correctly aligned on top of the custom built formers. This layering process is finished with a final coating of silicon allowing a vacuum to form in the oven, eradicating air holes within the structure.

Five huge ovens sit in the room adjacent, in varying sizes, the largest big enough to take the entire H160 frame. The parts are wheeled into the ovens on the frames where temperatures reach around 180ºC under pressure of around 7 bar , bonding all the layers ensuring a good ‘bake’. 

Following baking the parts cure on the formers before the silicon is peeled off and any rough edges are filled, and checked. A visual inspection is carried out on each composite part, before undergoing an ultrasound scan to identify any imperfections. We watch as two robotic arms work in unison to scan every square inch of each part using jets of water, this was the first (and only) use of robotics that we witnessed.

Now it is time to move onto the assembly line where we really start to see the helicopters come to life. There are 2 main lines, one with H135’s and the other H145’s progressing from the back of the factory floor where the composite parts are assembled, along to the electronics and cabling, next to avionics and finally to finishing. Each station being highly specialised and with at least 2 / 3 people working on each airframe at a time. The final assembly line of H135 and H145 comprise 5 main stations:

1. Mechanical installation

2. Electrical installation

3. Completion 

4. Finishing  (including Painting)

5. Flight Line

Our last stop on the tour is a visit to the H160 Airframe ‘Major Component Assembly’ where airframe number three is nearing the end of its time at Donauwörth. It will then be shipped to Marignane for the final assembly line, in line with Airbus Helicopter’s site specialisation strategy.

So thats the story, from the production of each composite part to finished airframe, the entire process taking around 3 months. A fantastic insight into how our helicopters come to life.

 

Article written by Luviair Operations Manager, Kerry Walker July 2018.

All images Copyright Airbus

Start today

With Luviair, private helicopters become a reliable part of your business and leisure

Get in touch
Copyright © Luviair 2026, Selection of images courtesy of Airbus